Click Images To Enlarge
High-Frequency Digital Splitter
(2-Way / One Port Power-Passive) $9.99

5-3000 MHz (3 GHz) High Frequency Splitter. Recommended for broad-band services, high-speed cable and satellite Internet or any other service where unwanted signal degradation is a factor - must have equipment for hi-definition signals.  Allows high bit rate transfer and communication. Alloy cast metal. Weatherproof housing. ONE port power-passing. Professional Quality.

FOUR-PACK High-Frequency Digital Splitters
(2-Way / One Port Power-Passive) $29.99

Same high frequency digital splitter detailed above. Buy more and save! Recommended for broad-band services, high-speed cable and satellite Internet. Allows high bit rate transfer and communication. Alloy cast metal. Weatherproof housing. ONE port power-passing. Professional Quality. Frequency Range = 5 to 3,000 MHz (3 GHz).

High-Frequency Digital Splitter
(2-Way / Both Ports Power-Passive) $9.99

5-3000 MHz (3 GHz) High Frequency Splitter. Recommended for broad-band services, high-speed cable and satellite Internet or any other service where unwanted signal degradation is a factor - must have equipment for hi-definition signals.  Allows high bit rate transfer and communication. Alloy cast metal. Weatherproof housing. BOTH ports power-passing. Professional Quality.

FOUR-PACK High-Frequency Digital Splitters
(2-Way / Both Ports Power-Passive) $29.99
5-3000 MHz (3 GHz) High Frequency Splitter. Recommended for broad-band services, high-speed cable and satellite Internet or any other service where unwanted signal degradation is a factor - must have equipment for hi-definition signals.  Allows high bit rate transfer and communication. Alloy cast metal. Weatherproof housing. BOTH ports power-passing. Professional Quality.

Dual Diplexer Signal Combiner and Splitter $19.99
Use this dual combiner outside to combine signals from the DirecTV 18-Inch Satellite Dish Antenna with terrestrial uhf/vhf signals from an off-air antenna. The combined signals travel a single coaxial cable into the home and are separated inside using diplexers before they enter the satellite receivers. Dual combiners eliminate the need to use an array of diplexers and splitters outside. Eliminates extra wiring thereby reducing cost of labor and installation materials necessary to run multiple coaxial drops. Designed for use with the DirecTV 18-Inch Round Dish Antenna.  Schematic

Qaud Satellite Diplexer Signal Combiner and Splitter $24.99
Use a quad combiner outside to combine signals from the DirecTV Phase III Satellite Dish Antenna with terrestrial uhf/vhf signals from an off-air antenna. The combined signals travel a single coaxial cable into the home and are separated inside using diplexers before they enter the satellite receiver. Quad combiners eliminate the need to use an array of diplexers and splitters outside. Eliminates extra wiring reducing cost of labor and installation materials necessary to run multiple coaxial drops. Designed for use with the DirecTV Phase III (ParaTodas or TripleSat) Dish Antenna. Schematic

DirecTV SWM Technology
Sonora #SDSWM-D2, SWM/CATV Horizontal Diplexer (2-2150 MHz) $9.99
use for Cable TV and DirecTV SWM separation and combining
The model SD SWMD2 is intended for CATV and SWM separation and combining. Model SD SWMD2 features low in-band insertion loss. SWM control 2.3 MHz and MVR / DECA isolation is 35 dB minimum. DIRECTV™ approved.

Basic Dish Network Satellite Diplexer Signal Combiner and Splitter $2.99
These Holland STVC Diplexers are approved for all standard Dish Network Satellite Installations. CAUTION: If you have a Dish Network DP44 Switch installed - you must use Holland DPD2 Diplexers listed below. These satellite diplexers are DISH NETWORK approved but are also compatible with DirecTV basic installations.

FOUR-PACK Basic Dish Network Satellite Diplexers $9.99
Same satellite diplexer as above. Buy more and save! A satellite diplexer is used outside to combine two separate signals: one signal from the satellite dish and another signal from either an off-air TV antenna or cable TV feed into a single coaxial cable. A second satellite diplexer is used inside to separate the combined signals. Satellite diplexers eliminate the need for extra wiring thereby reducing the cost of labor and installation materials necessary to run two coaxial drops. DISH NETWORK approved but are also compatible with DirecTV.

Advanced Satellite Diplexer Signal Combiner and Splitter $3.99
We recommend these Holland DPD2 Diplexers for all Dish Network Satellite Installations. Frequency range (5-2150 MHz) is greater than our Holland STVC diplexers which have a frequency range of 5-2050 MHz. These diplexers have a lower insertion loss, filter harmonics in the off-air spectrum from satellite conversion devices and allow 2 amp continuous power passing without burning out (necessary in DP44 installations). These satellite diplexers are DISH NETWORK approved but are also compatible with DirecTV.

FOUR-PACK Satellite Diplexer Signal Combiner and Splitter $12.99
Same satellite diplexer as above. Buy more and save! We recommend these Holland DPD2 Diplexers for all Dish Network Satellite Installations. Frequency range (5-2150 MHz) is greater than our Holland STVC diplexers which have a frequency range of 5-2050 MHz. These diplexers have a lower insertion loss, filter harmonics in the off-air spectrum from satellite conversion devices and allow 2 amp continuous power passing without burning out (necessary in DP44 installations). These satellite diplexers are DISH NETWORK approved but are also compatible with DirecTV.

Eagle Aspen Wide-Band (P7002)
2-Way Signal Splitter - One Port Power Passive $2.99

Use these Eagle Aspen 2-Way Splitters in conjunction with either a 4 X 8 or 5 X 8 multi-switch to expand your DirecTV Phase III (Triple-Sat) Dish antenna from 4 ports out to 16 ports out and POWER UP TO SIXTEEN DirecTV SATELLITE RECEIVERS with a single dish.  5-2600 MHz.

DISH Pro Plus Separator for Dish Network Installations $9.99
The DISH Pro Plus Separator is to be used in conjunction with a DISH Pro Plus switch or DISH Pro Plus LNBF to connect the two satellite tuner inputs of a DISH Pro Plus-compatible dual- tuner receiver using one cable. Click on the picture for more information concerning this item.  Schematic Here.

DirecTV® 2-WAY, 4-WAY and 8-WAY SWM Splitters - Priced Accordingly
are designed for use with DirecTV Single Wire Technology.  These are NOT common splitters and are NOT stand-alone products - use only in conjunction with the DirecTV® SWM8 Single-Wire MultiSwitch or the DirecTV® SL3S (3-HEAD) or the SL5S (5-HEAD) LNBFs.  Splits single output port on the SWM switch or LNBF - creates two, four or eight output signals for select receivers.  Click Here for more information on SWM (Single-Wire) Technology.
SWM Splitter

2-WAY SIGNAL UHF/VHF 75 OHM SIGNAL SPLITTER  $1.00
FREQUENCY RANGE: 5 - 1000 MHz. DC ~ SIGNAL ONLY. NON-POWER PASSIVE. Signal splitters are used primarily to add additional outlets to your existing cable TV service or split the output of your satellite receiver.

3-WAY SIGNAL UHF/VHF 75 OHM SIGNAL SPLITTER  $1.49
FREQUENCY RANGE: 5 - 1000 MHz. DC ~ SIGNAL ONLY. NON-POWER PASSIVE. Signal splitters are used primarily to add additional outlets to your existing cable TV service or split the output of your satellite receiver.

4-WAY SIGNAL UHF/VHF 75 OHM SIGNAL SPLITTER  $1.79
FREQUENCY RANGE: 5 - 1000 MHz. DC ~ SIGNAL ONLY. NON-POWER PASSIVE. Signal splitters are used primarily to add additional outlets to your existing cable TV service or split the output of your satellite receiver.

8-WAY SIGNAL UHF/VHF 75 OHM SIGNAL SPLITTER  $4.49
FREQUENCY RANGE: 5 - 1000 MHz. DC ~ SIGNAL ONLY. NON-POWER PASSIVE. Signal splitters are used primarily to add additional outlets to your existing cable TV service or split the output of your satellite receiver.